Process and points for installing the sunroof glass
[China Glass Net] Skylight glass installation may be a lot of trouble for the owner of the decoration. Today, Xiaobian will talk about the process and key points of the installation work: Men's Shirt,Pocket Dress Shirts,Plain Dress Shirts,Men Dress Yarn Dyed Shirt Shaoxing Bosheng Garment-Making Co.,Ltd. , https://www.boshengshirt.com
1. Prepare to remove debris, dust, etc. from the slot of the frame fan. The glass should be cut and the size of the glass should be in accordance with the design requirements. The edges should be straight and straight, and the gap with the notch should be appropriate. The drain hole at the lower edge of the frame fan should be unblocked.
2. After the preparation is finished, it is necessary to start installing the glass. The following summarizes the installation method of the sunroof glass:
1) The glass orientation of the design is required. Place the glass on the positioning block. When the opening fan and the glass area are large, the spacer should be placed at the vertical side position. The width of the positioning pad should be greater than the thickness of the supported glass, and the length is not less than 25 mm. An alloy gasket can be arranged under the positioning block, and the spacer and the gasket are fixed on the frame fan. The glass is placed in the notch, and the plug is filled with the material and the inlaid strip to make the glass evenly stressed, and the whole is smooth without warping; the glass on the windward side should be fixed immediately with a gasket or a long inlaid bead, and at the corner A small amount of sealant seal should be applied to improve its tightness.
2) Install the glass on the inclined sunroof, and follow the direction of the water. Take the method of cover stacking and fasten the clips. When the slope of the inclined sunroof is less than 25%, the amount of contact between the two glasses is about 50nun; when the slope is greater than 25%, the amount of the contact is about 35nun. The overlapping gaps of the joints should be covered with sleeve paper and compacted with rust-proof sleeves mixed with red dan.
3) The variety and specifications of the glass used in the sunroof should meet the design requirements. If there is no design requirement, it is better to use the brushed glass that is not easy to damage; when ordinary dry glass can only be installed, the steel mesh should be installed under the glass to Protection against glass damage.